Topic: Fluid Reservoir for CB,s with Radial master cylinder

[1080]

Will post pics soon,  this billet piece is made to blend Honda styling with the modern radial masters. It does have that Honda look.

[1080]

Fluid reservoir for cb's by 754.

[754]

Thanks 1080,
The rib that the fitting goes into extends across to the other side, it will have a tapped hole in it for mounting, either underneath ay 90deg to the fiting on the far side, or180 deg from the fitting, ot through the side of the rib.

[tank410]

hey 1080 any chance we could see pics of this on the bike?

[rhinoracer]

You just beat me to it! I was going to mount mine into the lathe to do the same. I hope mine ends up half as nice as yours.

[754]

I would like to see it on the bike (1080 put the pics ip for me)

I could do the smaller versions, but it is probably easier if I used the stock cap and seal (or at least had a cap to mesure & seal can be bought at a local dealer)