My neighbour has just acquired the above mentioned HD boat anchor, it's now in the UK, but it started life in the US and came over about 2 years ago in a state of electrical disrepair.
The core of the loom is there but the section that goes from the main multi-plug over the engine to the headlamp is absent. all the wires that run into the headlamp bowl from the ancillaries have been cut through at some point.
I have no problem building him a complete new loom if required, but a diagram of what should have been there originally would be nice
We don't even know if the thing runs yet, there's oil in the tank, and it looks clean enough, but the bar ends are bare, there are no lights or instruments whatsoever
We're gonna put power onto the starter motor tomorrow to see if everything spins up OK, but we do know it turns freely by hand already
