Topic: CB 350 roadrace 2-1 Headers.

[754]

Just got these, they are chrome but no baffle.

Collector is under engine rt hand cover of engine.

I held them up to a CB 350 without pipes on it, it looked like they would go on if the footpeg bar is removed..ie rearsets on the bike.they are splayed 45 degrees.. pipe at flange measures 6 3/16 c-c. primaries are 20 inches long @ 1.5 od, collector 8 inches long, exit is 1.75 od.

I will be selling but want to confirm fitment.

[bill440cars]

       Hey 754, are you saving the picture til you make sure they will fit? Just wondered. Waitin' to see.

[754]

Bad news bud, I have never posted pics on this forum..

 If I am lucky sometimes I used to get a buddy to take them for me, but seems he is busy till 2010.

 Slight chance I can get a phone-camera buddy to take a few  and maybe email them.

 Guess I am stuck to accurate descriptions and my stellar ebay reputation...

[crazypj]

Unless its aftermarket, it sounds more like a CJ360 system.
 Don't think it will go on a CB350.
PJ

[754]

Aftermarket for sure. Also the collector is vertical, that is one pipe over the other.

Look a lot like crossover TT pipes on a Triumph

What is a CJ 360?

[tbpmusic]

What is a CJ 360?

CJ360T:::
Produced in 1976,1977. 1976 model sold concurrently with the last version of the "normal" CB360T.
360 engine,  2-into-1 pipes, fibergalss "tail section" over rear fender.
Two variations, one ('76)with front disk, chrome fenders, and 6-speed tranny, the other ('77) with front drum, painted fenders, and 5-speed.
Not a big seller, seldom seen these days - everyone had "Four Fever" by then.

bill2

[SSCR]

Either CJ360 exhaust, which looks very nice or MAC 2 to 1 exhaust is also like that, trust me I have checked.

[bill440cars]

Bad news bud, I have never posted pics on this forum..

 If I am lucky sometimes I used to get a buddy to take them for me, but seems he is busy till 2010.

 Slight chance I can get a phone-camera buddy to take a few  and maybe email them.

 Guess I am stuck to accurate descriptions and my stellar ebay reputation...

           If you COULD get your buddy to take a (or some) shot(s) of the pipes, send them to me and I'll give it a shot and see if I can post it)them) for you.

[754]

Not like the MAC 360 at all.

 Collector is vertical and beside the engine cover, maybe even higher thn bottom of frame.. probably for roadrace or flattrack..

[crazypj]

The MAC 360 exits left side and is real low.
I have pics posted of one in my CB360 trackbike thread
(Project Shop, http://forums.sohc4.net/index.php?topic=30210.0, in the photobucket link, forget which page)
PJ

[Killer Canary]

Does anyone know what these are? I picked em by eyeball from a pile at the wrecker. The headers came with a chrome meg/ collector that didn't fit too well but when I separated the headers you can see how nicely they fit the motor and frame. They weren't welded to the collector, just a slip fit. No brand name on anything, but definitely aftermarket, headers are slightly bigger diameter than stock CB 350 twin.Must be for something in the 350/360/450 twin family.
Any ideas?