« previous next »
Pages: [1]   Go Down

Author Topic: HELP!! I installed a new clutch and now it slips reallly bad!! What did I do??  (Read 1941 times)

0 Members and 1 Guest are viewing this topic.

Offline CB750R

  • Hot Shot
  • ***
  • Posts: 609
  • 77 CB750F
HELP!! I installed a new clutch and now it slips reallly bad!! What did I do??
« on: April 23, 2005, 03:12:19 PM »
 ???

How do I fix the mess I have created?? I've adjusted everything I can, I've had the Clutch in and out 3 times now!?!?!?! I had to walk away or I was going to start throwing tools!!!

Any suggestions that are a bit more productive?

Logged

scottgarland

  • Guest
Re: HELP!! I installed a new clutch and now it slips reallly bad!! What did I do??
« Reply #1 on: April 23, 2005, 04:56:10 PM »
Did you use a shop manual for instructions? Check to see if frictions plates and clutch plates are in correct order. Usually things like this are because of a small oversight. Relax go back to the bike after you take a breake, then reread the book, you will probably find the answer once your not stressed out  Scott in San Diego
Logged

BarryKelly

  • Guest
Re: HELP!! I installed a new clutch and now it slips reallly bad!! What did I do??
« Reply #2 on: April 24, 2005, 03:52:29 PM »
Some oils contain friction reducing additives, which can cause the clutch to slip.  In your rebuild of the clutch did you use any of these?

Barry
Logged
Pages: [1]   Go Up
« previous next »