« previous next »
Pages: [1]   Go Down

Author Topic: Wheel hub questions.  (Read 783 times)

0 Members and 1 Guest are viewing this topic.

Offline Caaveman82

  • Zippo
  • Master
  • *****
  • Posts: 2,299
  • That'll do pig. That'll do.
Wheel hub questions.
« on: March 12, 2009, 12:49:53 PM »
I am going to make an attempt at powder coating my wheels.

I have a couple questions before hand.

Just took the rear one apart. There is a little rubber gasket type thing on the inside of the plate that goes over the sprocket, is this removeable?

Second, are there any rubber gaskets or anything on the front wheel hub that I should know about that might be destroyed in 380 degree heat?
Logged
Do not act as though you could kill time without injuring eternity. - Dave Thoreau

Offline HavocTurbo

  • Angry little bastard of an
  • Old Timer
  • ******
  • Posts: 3,739
  • Can you tell?
Re: Wheel hub questions.
« Reply #1 on: March 12, 2009, 12:57:59 PM »
rubber gasket? what year? Got a pic?

Your front hub should have the bearings removed before hand. That should be about it.

Same for the rear also.
Logged
'48 HD Panhead - Exxon Valdez
'78 CB550K - Fokker CB.3
'78 Honda CB750K - Mavrik
'80 Yamaha XS850G - Kanibalistik
09 XL883L - No Name

Offline Caaveman82

  • Zippo
  • Master
  • *****
  • Posts: 2,299
  • That'll do pig. That'll do.
Re: Wheel hub questions.
« Reply #2 on: March 12, 2009, 02:27:26 PM »
75 CB550F

I will post pics tomorrow. Camera is at home.
Logged
Do not act as though you could kill time without injuring eternity. - Dave Thoreau
Pages: [1]   Go Up
« previous next »