Author Topic: tach cap  (Read 1199 times)

0 Members and 1 Guest are viewing this topic.

Offline andy8190

  • Expert
  • ****
  • Posts: 1,001
tach cap
« on: September 17, 2009, 12:30:20 AM »
so i had a stuck screw and hit it with the impact and snapped my tach cap. i was wondering if anyone sees a problem with me trying to jb weld it back together. As long as it will still seal properly will it hurt anything until i get a replacement?

Offline Steve F

  • I have "some-timer's disease" because I'm an
  • Old Timer
  • ******
  • Posts: 2,929
  • "To Ride Is The Reason, The Destination The Excuse
Re: tach cap
« Reply #1 on: September 17, 2009, 09:58:27 AM »
Tach CAP???   ???  WachutakkinboutWillis? 

Offline andy8190

  • Expert
  • ****
  • Posts: 1,001
Re: tach cap
« Reply #2 on: September 17, 2009, 10:48:21 AM »
number 19 in the pic, top left corner, it holds the cable in




Offline Gordon

  • Global Moderator
  • Really Old Timer ...
  • *****
  • Posts: 12,114
  • 750K1, 550K2
Re: tach cap
« Reply #3 on: September 17, 2009, 10:52:25 AM »
As long as it didn't break across the surface where the oil seal sits I don't see why some JB weld wouldn't work. 

Offline andy8190

  • Expert
  • ****
  • Posts: 1,001
Re: tach cap
« Reply #4 on: September 17, 2009, 11:44:04 AM »
i dont think it did, hopefully another member will have one though as well, i have been asking around

Offline Gordon

  • Global Moderator
  • Really Old Timer ...
  • *****
  • Posts: 12,114
  • 750K1, 550K2
Re: tach cap
« Reply #5 on: September 17, 2009, 11:49:14 AM »
Look on ebay, too, for the whole valve cover.  If you can find an ugly one for cheap, that may be a good route to go.  Then you can just take the part off that you need. 

Offline andy8190

  • Expert
  • ****
  • Posts: 1,001
Re: tach cap
« Reply #6 on: September 17, 2009, 12:15:57 PM »
yeah no luck on ebay

Offline Gordon

  • Global Moderator
  • Really Old Timer ...
  • *****
  • Posts: 12,114
  • 750K1, 550K2
Re: tach cap
« Reply #7 on: September 17, 2009, 12:32:11 PM »
I just remembered I have a spare valve cover for a 550 in my garage. :)  PM me your address and I'll send the tach drive gear housing to you.  It still has the oil seal in it, which should still be in good shape.   

Offline andy8190

  • Expert
  • ****
  • Posts: 1,001
Re: tach cap
« Reply #8 on: September 17, 2009, 12:39:47 PM »
thank you so much man, pm sent