« previous next »
Pages: [1]   Go Down

Author Topic: Problem with #4  (Read 1082 times)

0 Members and 1 Guest are viewing this topic.

grapppa

  • Guest
Problem with #4
« on: October 22, 2005, 02:05:39 PM »
I did a complete tune up and got the timing right on.  Idles OK.  However, #4 is significantly colder and is firing only intermittently.  When setting the timing I used #4 and did get a spark.  I disconntected all leads to plugs, unscrewed the plug cap and made sure that the connections were clean.  While running I disconnected the plug wire on #4 and it was a noticable difference.  This could explain the general lack of power...Any suggestions ???
« Last Edit: October 22, 2005, 02:12:21 PM by grapppa »
Logged

Offline TwoTired

  • Really Old Timer ...
  • *******
  • Posts: 21,805
Re: Problem with #4
« Reply #1 on: October 22, 2005, 02:15:40 PM »
Is your compression even across the cylinders?
Have you synchonized the carbs?
Are all the idle screws set the same?
Are all the slow circuits in the carbs clean and clear?
Are there any leaks in the runners between carb and head?
Cheers,
Logged
Lloyd... (SOHC4 #11 Original Mail List)
72 500, 74 550, 75 550K, 75 550F, 76 550F, 77 550F X2, 78 550K, 77 750F X2, 78 750F, 79CX500, 85 700SC, GL1100

Those that learn from history are doomed to repeat it by those that don't learn from history.

harpo

  • Guest
Re: Problem with #4
« Reply #2 on: October 22, 2005, 07:02:58 PM »
are you getting any gas too #4
Logged
Pages: [1]   Go Up
« previous next »