Topic: Cutting tubing on angles

[Bouncer]

What is the easiest way to cut tubing on specific angles? I have been trying to figure out the easiest way, but cant find anything easy. I have tried the angle grinder, hacksaw, grinding with a wheel, sawzall, attempted to using a cut off wheel in my miter saw, etc...

Anyone got any ideas?

It was alot easier on paper, much like everything else...... 

[cb650]

A good chop saw or band saw.  I would have thought your miter with a cutoff wheel would have worked.

[Steve F]

What kind of material, size, wall thickness are we talking about here?  I've had good luck with a bandsaw using a fine pitch blade, especially if the wall thickness is pretty thin.
I use an up-side-down drill press vise to hold the material while cutting to keep the material from spinning in your hand.

[Ricky_Racer]

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=42324     RR

[BlindJoe]

horizontal bandsaw

[754]

Cold saw if you are doing lots of it..

 not what I use though, but it is the best..

[tramp]

seems like everything you named would do the job well

[1timduke]

You could ask this guy for help

-Tim

Seriously though, my fave is the angle grinder w/ a cutting wheel with the tube in a vise.   Always wear safety glasses, metal in your eye sucks a$$.