« previous next »
Pages: [1]   Go Down

Author Topic: Carb torsion spring  (Read 908 times)

0 Members and 1 Guest are viewing this topic.

Offline oldfett

  • Enthusiast
  • **
  • Posts: 145
Carb torsion spring
« on: May 14, 2009, 07:36:34 PM »
Hey all,

I am on the home stretch of getting my "newest" 750 on the road but I need to finish up the carbs. Where and how does the torsion spring sitting between carbs 2 and 3 hook up? This is a 1975 CB750.

Thanks!
Logged

Offline wrenchmuch

  • Hot Shot
  • ***
  • Posts: 698
Re: Carb torsion spring
« Reply #1 on: May 14, 2009, 09:26:26 PM »
In this view below #14 which is the spring you can see a plate . This plate goes between #2 and #3 in a large hole that faces one another . Bottom of the spring goes to this plate .   http://www.bikebandit.com/houseofmotorcycles/showschematic/m9235sch397870
Logged
CB750K1
CB750K4

Offline oldfett

  • Enthusiast
  • **
  • Posts: 145
Re: Carb torsion spring
« Reply #2 on: May 14, 2009, 09:59:13 PM »
That one is hooked up ok I am having problems with the other spring. It looks very similar to these...

Logged

Offline Venturous

  • CB750 Hack Pilot
  • Enthusiast
  • **
  • Posts: 169
    • eMotorcycling
Re: Carb torsion spring
« Reply #3 on: May 17, 2009, 01:39:24 PM »
Replying just to get notifications. I have the exact same question.
Logged
eMotorcycling
'72 CB750-K1 w/Spirit Eagle sidecar
'02 Royal Star Midnight Venture
Pages: [1]   Go Up
« previous next »