« previous next »
Pages: [1]   Go Down

Author Topic: Shift Fork Shaft Question  (Read 605 times)

0 Members and 1 Guest are viewing this topic.

Offline devriems

  • Full Member
  • *
  • Posts: 29
Shift Fork Shaft Question
« on: October 25, 2009, 12:26:17 PM »
I'm putting the transmission back together on my 75 CB750K and I didn't take note as to how the fork shaft goes back in.  Basically, one end of the shaft is indented while the other end is solid.  Anybody know which end goes in first?
Logged

Offline HondaMan

  • Someone took this pic of me before I became a
  • Really Old Timer ...
  • *******
  • Posts: 14,054
  • ...not my choice, I was nicknamed...
    • Getting 'em Back on the Road
Re: Shift Fork Shaft Question
« Reply #1 on: October 25, 2009, 01:41:02 PM »
If you mean the end that is hollowed out a little (as "indented"  ??? ), that end goes toward the chain side of the engine (left side).
Logged
See SOHC4shop@gmail.com for info about the gadgets I make for these bikes.

The demons are repulsed when a man does good. Use that.
Blood is thicker than water, but motor oil is thicker yet...so, don't mess with my SOHC4, or I might have to hurt you.
Hondaman's creed: "Bikers are family. Treat them accordingly."

Link to Hondaman Ignition: http://forums.sohc4.net/index.php?topic=67543.0

Link to My CB750 Book: https://www.lulu.com/search?adult_audience_rating=00&page=1&pageSize=10&q=my+cb750+book

Link to website: www.SOHC4shop.com

Offline devriems

  • Full Member
  • *
  • Posts: 29
Re: Shift Fork Shaft Question
« Reply #2 on: October 26, 2009, 05:02:43 PM »
Yup.  That is the end I meant.  Thanks.
Logged
Pages: [1]   Go Up
« previous next »