Quick ball bearing replacement in lower case when it went as planned!
Heat gun made case warm, ball bearing fell out with help of a heavy bolt with nut and a finger knocked the nut. Very smooth, no force at all.
The other way worked perfect when the new frozen bearing fell in and bottomed the seat in the warm case with a nice klonk!
A small help of a alu pipe with same diam as outer race
I remembered the threads whith guys having problems with replacing the neutral switch. The shift drum must not be seated all the way in, the neutral switch will hit the drum. In with the neutral switch with oiled 183 o-ring on, pull the drum a little and the switch has free way to bottom. I used a socket of same diameter and a gentle tap with a rubber hammer.
Next step is the primary chains and crank and verify the clearances with brown shells. If too tight I'll use my good greens.
Double check the gear shift function and no missing/misplaced small parts in the trans, gear selector....Hopefully tomorrow after work.