Author Topic: What size is the adjusting sync nut on carbs?  (Read 754 times)

0 Members and 1 Guest are viewing this topic.

Offline Really?

  • I've come to the conclusion that I AM a
  • Really Old Timer ...
  • *******
  • Posts: 5,276
What size is the adjusting sync nut on carbs?
« on: May 24, 2010, 12:17:38 PM »
Ok, i bought a MotionPro CarbSync.  Waste of money.

Looking at the CarbTune since the Euro is in my favor - http://www.carbtune.com/  
 Hearing about $80 shipped.

See this sync nut/screw tool and an wondering what size it is - http://www.carbtune.co.uk/carbtool.html - It says it is 8mm.  What size are the four for the k5?  If it is the right size, have y'all used this and is it worth it?  I have not synced the carbs yet.
I don't have a motorcycle, sold it ('85 Yamaha Venture Royale).  Haven't had a CB750 for over 40 years.

The Wife's Bike - 750K5
The Kid's Bike - 750K3

Offline Duke McDukiedook

  • Space Force 6 Star General
  • Really Old Timer ...
  • *******
  • Posts: 12,690
  • Wish? Did somebody say wish?
Re: What size is the adjusting sync nut on carbs?
« Reply #1 on: May 24, 2010, 01:14:41 PM »
I found that adjusting the slide height for synching was done easiest with bicycle cone wrenches for bicycle hubs.
« Last Edit: May 24, 2010, 01:31:21 PM by Dukiedook »
"Well, Mr. Carpetbagger. We got somethin' in this territory called the Missouri boat ride."   Josey Wales

"It's Baltimore, gentlemen. The gods will not save you." Ervin Burrell

CB750 K3 crat | (2) 1986 VFR750F