Topic: 78 750f front brake line picture

[2wheels]

Could someone take a picture (or 2) of the brake line routing from the Master cylinder to the 3 way joint.
I don't think mine is correct, it has tight bends that just don't look right to me.

I'm putting new lines on and want to make sure it's correct.

Thanks

[2wheels]

Here is a picture.  Does this look right?

[mick750F]

   No, that's not right. I'm spending some shop time with mine tomorrow. If you haven't gotten what you need by tomorrow night I'll post some pics.

Mike

[2wheels]

That would be Great.
Thanks Mike

[2wheels]

Here is a picture showing the handle bars.
I was wondering if they are not stock.  Which would explain the tight turns in the brake line.

[mick750F]

   Hey 2wheels, I never made it to my shop yesterday but spent time there today...without a camera. The routing for the line is pretty straight forward. It runs off the master, through the bracket that holds the speedo/tach, and then to the splitter. With yours looking like it does I'd guess that the line is a replacement and too long. It would be just about impossible to get a proper length line to look the way yours does

HTH...Mike

[Don R]

Those bars look a little lower than stock.

[mick750F]

Those bars look a little lower than stock.

   Yeah, that would explain it too.

Mike

[2wheels]

Ok
I have a new line (actually I'll replace all 4 lines with ss braid from pampadori) on order.
Hopefully I can route it so the bends are not so tight.

I have been looking at handle bars, can anyone tell me the stock height for my 78 750F?
And where I might find a set, just in case I decide to change.

[2wheels]

The brake line is sorted out.

Now I find if I ride longer than 30 minutes my hands are numb.

Is it these low bars?  See the picture up a couple posts.

There is vibration on the bars.  Any ideas