Author Topic: Ring end gap? (Read 1109 times)

Slapguts · « **on:** February 27, 2006, 04:23:33 PM »

Finally got a set of rings for the old 750, and they seem awful close when in the bore. Checked my manual, and it lists nothing about what is too tight a gap, just what is too big.

Anyone know how much of a gap I need? They're NOS rings, standard bore. I thought they'd be right out of the box, but...

bwaller · « **Reply #1 on:** February 27, 2006, 04:34:16 PM »

I always used 0.018" ring end gap, what have you got?

Slapguts · « **Reply #2 on:** February 27, 2006, 04:48:20 PM »

Quote from: bwaller on February 27, 2006, 04:34:16 PM

I always used 0.018" ring end gap, what have you got?

Not sure, but it has to be less than that. .018 sounds good. A set of valve springs and some gaskets, ans I have an engine again. Woo-hoo!

MRieck · « **Reply #3 on:** February 27, 2006, 06:20:00 PM »

.004" for every inch of bore in general

bryanj · « **Reply #4 on:** February 28, 2006, 06:28:35 AM »

If they are original Honda i doubt that the gap is wrong

SOHC/4 Owners Club Forums

News:

Author Topic: Ring end gap? (Read 1109 times)

Slapguts

Ring end gap?

bwaller

Re: Ring end gap?

Slapguts

Re: Ring end gap?

MRieck

Re: Ring end gap?

bryanj

Re: Ring end gap?