Hi all - unfortunately I have to move on one of my projects
I will piece it together as a roller for sale.
Its a K series - stock frame
Parts collected for project as follows
-GS1000 alloy swingarm (2" longer than stock I think) spaced up and ready to roll
-Cycle exchange billet tripple trees (never been used) plus stock
-Mags (front single disc / rear drum - would need spacers, may get round to making them)
-Rask rearsets (new in box)
-old Dunstal clip -ons (bit rough)
-One piece fibreglass seat and tank unit - looks like Dunstal? (Is a twin seater but I had intended to cut it down to a single)
-4 into 1 race pipe (never been used - built by Mick from Tranzac)
-PO installed new wiring loom - looks good.
-Showa gas shocks
Think thats about it....
The motor ran but was rough.... I have no history on it.
- I have a new set of clutch plates to go with it as it seemed like it needed them when I purchased it?
I will try and get it together by next weekend and upload some pix.
I am looking for reasonable offers - if not it'll be up on ebay.
PM me if interested or email blackphotograhix@bigpond.com.au
Thanx
Matt
