« previous next »
Pages: [1]   Go Down

Author Topic: K1 oil tank  (Read 493 times)

0 Members and 1 Guest are viewing this topic.

Offline phil71

  • Master
  • *****
  • Posts: 1,813
K1 oil tank
« on: April 25, 2011, 04:59:53 PM »
the bottom nipple on my k1 has brazing around it. Is this how it was originally held to the steel tank, or did someone make a lame repair?
 I think I may already know the answer.
Logged

Offline wrenchmuch

  • Hot Shot
  • ***
  • Posts: 698
Re: K1 oil tank
« Reply #1 on: April 25, 2011, 05:13:42 PM »
I can't tell on my K1 because there's paint on the weld/braze . If there's no paint on yours that might be a good indication that it got twisted out and was repaired . I have a tank that I'm afraid I will twist the bung out of if I wrench much harder on it .
Logged
CB750K1
CB750K4

Offline phil71

  • Master
  • *****
  • Posts: 1,813
Re: K1 oil tank
« Reply #2 on: April 25, 2011, 05:17:35 PM »
oh, it's painted.. or it was. but it's been leaking ever so slowly, so i got in there to see what was up. I reflowed the brazing.. seems to be tight again. I just wondered if it was a factory braze, or someone effecting a repair at some point. Hard to tell.
Logged
Pages: [1]   Go Up
« previous next »