« previous next »
Pages: [1]   Go Down

Author Topic: cam profile  (Read 1386 times)

0 Members and 1 Guest are viewing this topic.

Offline topgun

  • Full Member
  • *
  • Posts: 43
cam profile
« on: June 08, 2011, 12:18:23 AM »
I am rebuilding anold MTC engine with a 900 kit big head rods studs and the cam has 319 numbers on it  The cam is a regrind, possibly done by Ivan Tighe in Brisbane Aust but only guessing, Engine originally built by Barry Taylor of Phase 4 Engineering Next question how do you measure lift and duration of the cam any help appreciated
Logged

Offline Retro Rocket

  • Eggs are hard due too a
  • Really Old Timer ...
  • *******
  • Posts: 19,279
  • ROCK & ROLL
Re: cam profile
« Reply #1 on: June 08, 2011, 12:37:31 AM »
Hi Topgun, i have seen the 315 on this site somewhere, could be a Russ Collins cam originally and been reground by Ivan Tighe, i had him regrind a RC cam for me a few years back at West End if my memory serves me right....Someone else here will know for sure....
Logged
750 K2 1000cc
750 F1 970cc
750 Bitsa 900cc
If You can't fix it with a hammer, You've got an electrical problem.

Offline mick7504

  • Old Timer
  • ******
  • Posts: 3,740
Re: cam profile
« Reply #2 on: June 08, 2011, 03:13:32 AM »
How are you mate

I have an old Ivan Tighe regrind that has "SM369" stamped into the end.

They were able to to give me the opening & closing degrees and lift from their records.
http://www.tighecams.com.au/contact.htm

Logged
If I was you
I'd be worried about me.

Offline topgun

  • Full Member
  • *
  • Posts: 43
Re: cam profile
« Reply #3 on: June 09, 2011, 12:44:50 AM »
Thanks guys just sent Ivan Tighe an e-mail hoping for a good result Did not know they were still around good to see a good aussie business still hanging in there Cheers Tony
Logged
Pages: [1]   Go Up
« previous next »