Author Topic: shaving down the weight on my 77 550F  (Read 974 times)

0 Members and 1 Guest are viewing this topic.

Offline psycherhexic

  • Full Member
  • *
  • Posts: 39
shaving down the weight on my 77 550F
« on: July 06, 2011, 02:04:49 PM »
what are some safe things to remove on one of these?

also.. things that aren't so safe, but doable: discuss!

thanks

Offline Gordon

  • Global Moderator
  • Really Old Timer ...
  • *****
  • Posts: 12,114
  • 750K1, 550K2
Re: shaving down the weight on my 77 550F
« Reply #1 on: July 06, 2011, 02:08:20 PM »
Lose the starter motor.

Offline sixthwisconsin

  • With an 1855 Springfield, I'm a
  • Hot Shot
  • ***
  • Posts: 553
Re: shaving down the weight on my 77 550F
« Reply #2 on: July 06, 2011, 02:45:40 PM »
Fenders, especially the rear. It weighs a ton.

Offline betterthanurs916

  • Enthusiast
  • **
  • Posts: 105
Re: shaving down the weight on my 77 550F
« Reply #3 on: July 06, 2011, 02:45:51 PM »
There is definitely a lot to be done and everything has a compromise.  I'll rattle off a quick list of things and put my forseeable downside in parenthesis next to it...

--Remove center stand (makes maintenance more of a pain)
--Remove side stand (you basically have to lean the bike against a wall or have a stationary stand for it anytime you want to stop)
--Remove turn singals (arguably less safe on the road)
--Remove front fender (more junk is going to fly on the bike and in your face)
--Remove rear fender (more junk is going to fly up the tail end of the bike, you'll need to figure out the tail lamp, and it might look a bit odd with the stock seat)
--Remove or replace mirrors with something smaller (good luck finding some that are as effective)
--Remove passenger pegs and cut off mounts (how are you going to cart around the hot babes???)
--Remove chain guard (slinging oil and crap all over the place)
--Remove grab-rail (not easy to tie things down if necessary without it)
--Cut speed holes in evertying (not super easy to do right, not a whole lot of downsides necessairily)
--Remove gauges and associated hardware (you can't tell how hard you're flogging your engine or how fast your lightweight killer is going)


Those are some of the quick and simple things, there are definitely more...but you start getting a little expensive and/or compromising streetability beyond there.
« Last Edit: July 06, 2011, 02:47:38 PM by betterthanurs916 »
1977 CB550F2

Offline psycherhexic

  • Full Member
  • *
  • Posts: 39
Re: shaving down the weight on my 77 550F
« Reply #4 on: July 06, 2011, 03:11:56 PM »
sweet. I was just looking at some specific points on the frame that seemed to be "extra" but I'm positive they are there for strength and probably should be messed with..


Offline sixthwisconsin

  • With an 1855 Springfield, I'm a
  • Hot Shot
  • ***
  • Posts: 553
Re: shaving down the weight on my 77 550F
« Reply #5 on: July 06, 2011, 03:50:29 PM »
...and my bike would be much faster if I could loose 20 lbs! ;)

Offline coldwave007

  • Enthusiast
  • **
  • Posts: 120
Re: shaving down the weight on my 77 550F
« Reply #6 on: July 06, 2011, 04:01:27 PM »
...and my bike would be much faster if I could loose 20 lbs! ;)

QFT - When I was 205lbs last year, my little 100cc enduro topped out at about 52-54Mph.  I'm now 172 lbs and it tops out 58-60Mph.  Cutting the fat really does help.

Other than that, the post above was pretty sweet about what can be dropped off the machine.  Beyond that you really get into the picky stuff (battery, size of headlamp, etc). 
1980 Honda CB650C Custom, 1972 Yamaha LT-2 100

Offline WarwickE36

  • Expert
  • ****
  • Posts: 761
Re: shaving down the weight on my 77 550F
« Reply #7 on: July 06, 2011, 04:12:36 PM »
Buy an R6, problem solved
" Why does anyone get offended by what someone does to their own bike? I dont get it. "

You made me think about it after I cheered knowing someone else would like to know what these control freaks are up to.
 Every time any owner strips whatever precious Honda part the horrified purists parts go up in value. That's not the part that bothers them.
 What bothers them is they sat up late at night, their breast full of wonder and estrogen, unable to sleep, dreaming about their lovely darling and all her glory... and next thing you know someone else doesn't share their emotional deluge and their reaction is they must spread their mind museum as far as they possibly can, taking over as much of the real world as possible.

Drink fast, drive slow, but ride it like you stole it

1974 Cb550 with style
2004 SV650s

Offline psycherhexic

  • Full Member
  • *
  • Posts: 39
Re: shaving down the weight on my 77 550F
« Reply #8 on: July 06, 2011, 05:07:07 PM »
Buy an R6, problem solved

not an option  ;D

so.. about losing the starter motor? uh  :o so then its kickstart only?

Offline madmtnmotors

  • When did I get to be a
  • Really Old Timer ...
  • *******
  • Posts: 6,109
  • Sunny Central Florida
Re: shaving down the weight on my 77 550F
« Reply #9 on: July 06, 2011, 05:11:05 PM »
When she has to stop for the umpteenth time to use the restroom...

Leave without her!
TAMTF...


Wilbur



Projects:
"Evolution": http://forums.sohc4.net/index.php?topic=100352.0
"P.O. Debacle": http://forums.sohc4.net/index.php/topic,126692.msg1441661.html#msg1441661
F2/F3 O-rings: http://forums.sohc4.net/index.php?topic=113672.msg1300721#msg1300721
Cam Tower Studs: https://www.mcmaster.com/#93210a017/=t19sgp
Clean up that nasty harness: http://forums.sohc4.net/index.php?topic=137351.msg1549191#msg1549191
http://forums.sohc4.net/index.php/topic,148188.msg1688494.html#msg1688494
http://forums.sohc4.net/index.php/topic,139544.msg1579364.html#msg1579364
                                          
Charging system diagnosis: http://forums.sohc4.net/index.php?topic=1012.msg8345#msg8345
Get the manuals: http://manuals.sohc4.net/cb750k/
The Dragon: http://forums.sohc4.net/index.php?topic=45183.msg1571675#msg1571675
Headlight Switch: http://forums.sohc4.net/index.php?topic=113986.msg1283236#msg1283236
Branden's leak free top end thread: http://forums.sohc4.net/index.php?topic=107040.0
Engine Lifting Made Easy: http://forums.sohc4.net/index.php/topic,58210.msg1684742.html#msg1684742
                                      http://forums.sohc4.net/index.php/topic,100352.msg1675840.html#msg1675840
Static and Dynamic Timing: http://www.hondachopper.com/garage/carb_info/timing/timing1.html
Airbox Gasket Replacement: http://forums.sohc4.net/index.php/topic,114485.msg1290000.html#msg1290000
"Café" : http://forums.sohc4.net/index.php/topic,84697.msg953814.html#msg953814
PD Carb Choke Linkage: http://forums.sohc4.net/index.php/topic,100352.msg1669248.html#msg1669248
                                    http://forums.sohc4.net/index.php/topic,110931.msg1248354.html#msg1248354
                                    http://forums.sohc4.net/index.php/topic,48858.msg515204.html#msg515204
Follow up on your damn posts: http://forums.sohc4.net/index.php/topic,144305.msg1791605.html#msg1791605
Taiwanese Cam Chain Tensioners:  http://forums.sohc4.net/index.php/topic,155043.msg1774841.html#msg1774841
Gumtwo Seat Cover: http://forums.sohc4.net/index.php/topic,164440.msg1897366.html#msg1897366
Primary Drive: http://forums.sohc4.net/index.php/topic,166063.msg1919278.html#msg1919278
Tank Latch: http://forums.sohc4.net/index.php/topic,165975.msg1919495.html#msg1919495
Shorten your forks: http://vintage-and-classic-honda-s.456789.n3.nabble.com/How-to-shorten-forks-td4042465.html DO NOT CUT THE SPRINGS!
Clutch How To: http://vintage-and-classic-honda-s.456789.n3.nabble.com/How-to-change-and-adjust-a-clutch-SOHC-td4040391.html
Late model K7/K8/F2/F3 front sprocket cover removal: http://forums.sohc4.net/index.php/topic,178428.msg2072279.html#msg2072279
630 to 530 conversion: http://forums.sohc4.net/index.php/topic,180710.msg2094423.html#msg2094423

Sent from my Tandy TRS-80!

Offline Retro Rocket

  • Eggs are hard due too a
  • Really Old Timer ...
  • *******
  • Posts: 19,279
  • ROCK & ROLL
Re: shaving down the weight on my 77 550F
« Reply #10 on: July 06, 2011, 06:08:50 PM »
Quote
--Remove front fender (more junk is going to fly on the bike and in your face)
--Remove rear fender (more junk is going to fly up the tail end of the bike, you'll need to figure out the tail lamp, and it might look a bit odd with the stock seat)

Removing the front fender removes the brace, which is going to destabilise the front some. If you want to remove the front fender, fit a fork brace... That is if you want the bike to handle...You can get cut down fibreglass rear fenders for the 750, i am not too sure about the smaller Honda's but they are definitely lighter. Don't remove the side stand it really doesn't weigh that much, the centre stand weighs a ton and is usually the first thing i remove. Aluminium rims, different discs, there's a ton of ways to remove weight, just make sure if it is structural or suspension that you are weight relieving that everything is just as strong or stronger than original....
750 K2 1000cc
750 F1 970cc
750 Bitsa 900cc
If You can't fix it with a hammer, You've got an electrical problem.

Offline psycherhexic

  • Full Member
  • *
  • Posts: 39
Re: shaving down the weight on my 77 550F
« Reply #11 on: July 06, 2011, 06:19:27 PM »
I think the original owner already shaved some off of both fenders... I'm planning on shaving even more, but keeping them there, that way the handling stays.. i think  :P

Offline Gordon

  • Global Moderator
  • Really Old Timer ...
  • *****
  • Posts: 12,114
  • 750K1, 550K2
Re: shaving down the weight on my 77 550F
« Reply #12 on: July 06, 2011, 06:24:20 PM »

so.. about losing the starter motor? uh  :o so then its kickstart only?

Well, I suppose if you always parked at the top of a hill you could bump-start it. ;)

Seriously, though, when these bikes are in a halfway decent state of tune, they kick-start very easily (especially the 550), and the starter motor weighs a lot.  Both my 550 and 750 have been kick-start only for about six years, and they're my main means of transportation.  My motivation wasn't weight savings, though.  The electric start stopped working on each one and I never bothered to fix them.  They both still have the starter motors. 

Also, by losing the starter motor you have the option of going with a smaller, lighter battery. 

Offline david 750f

  • Expert
  • ****
  • Posts: 827
  • 1976 CB750F
Re: shaving down the weight on my 77 550F
« Reply #13 on: July 07, 2011, 12:05:02 AM »
I have to disagree with Coldwave. Weight has very little effect on top speed. Unless his frontal area (drag) decreased. Weight only has an effect on acceleration. Two up on my CB750F I reach the same top speed, albeit in a much longer distance.
1976 CB 750F

Offline xsmooth69x

  • Master
  • *****
  • Posts: 1,621
Re: shaving down the weight on my 77 550F
« Reply #14 on: July 07, 2011, 02:18:19 AM »
dont they make that thing where you can ditch the battery and the big alternator thing on the opposite side of the points side.

i forgot what it was called..... maybe magneto or something? i remember it reminded me of the evil dude in x-men  :P
1975 CB550 (FINISHED?!?!?)
first motorcycle ever!!! ow and i dont know how to ride it either :D

raw rust rice venti quad shot cafe racing latte project aka my build..... http://forums.sohc4.net/index.php?topic=88853.0

black and white equation godzilla chalkboard 
1972 cb750 - next in line for some <3