Author Topic: CB500K clutch plate spec  (Read 980 times)

0 Members and 1 Guest are viewing this topic.

Offline thanantos

  • Full Member
  • *
  • Posts: 30
CB500K clutch plate spec
« on: July 15, 2011, 05:46:07 AM »
I just checked the friction plates on my recently purchased CB500K (for which I have no history) and they all measure out between 3.30mm and 3.33mm.

Problem is the specs in the manual show 2.6mm with 2.3mm being the low spec.

Is this a problem?
2009 KLR650
1971/72 Honda CB500

Offline camelman

  • Man... Myth... Legend
  • Master
  • *****
  • Posts: 1,899
Re: CB500K clutch plate spec
« Reply #1 on: July 15, 2011, 06:31:01 PM »
I had an overly thick set in a 350f engine I swapped into my bike. The clutch did not work until I replaced the friction disks with a spare used set I had that were thinner. Does your clutch work?
1972 350f rider: sold
1972 350f/466f cafe: for sale
1977 CB400f cafe:sold
1975 CB400f rider: sold
1970 CB750 K0 complete bike: sold
2005 Triumph Sprint ST 1050 rider

We've got to cut it off... and then come down on rockets.  (quoted from: seven minutes of terror)

Offline haill

  • Hot Shot
  • ***
  • Posts: 319
Re: CB500K clutch plate spec
« Reply #2 on: July 16, 2011, 04:55:40 AM »
in my honda cb500 shop manual printed in 1972 it states the friction disk thickness as 3.3 mm [0.13] and the service limit as 3.0 mm [0.11]

Clutch spring free length as 31.9 mm    Service limit 30.5 mm

Offline thanantos

  • Full Member
  • *
  • Posts: 30
Re: CB500K clutch plate spec
« Reply #3 on: July 16, 2011, 08:38:27 AM »
Unknown if it works right now. I have the r. side cover off and can see 2 to 3mm of movement on the pressure plate.

Glad to hear on the manual. I have no idea why mine says 2.3mm unless they are referring to the grey metal plates in between the clutch plates?
2009 KLR650
1971/72 Honda CB500