Author Topic: Benefit Auction (Read 40097 times)

FuZZie · « **Reply #75 on:** January 02, 2012, 05:56:32 PM »

You sure sam that url is for posting?

Quote

action=post

Sam Green Racing · « **Reply #76 on:** January 03, 2012, 01:40:32 AM »

Thanks FuZZie, the beer was good last night.

It's corrected.

Sam.

FuZZie · « **Reply #77 on:** January 03, 2012, 06:00:47 AM »

You know a website is out there for him, I'll drop you a url you can add it to your original post if you wish.

http://www.mikethebike.com/biography.htm

Terry in Australia · « **Reply #78 on:** January 03, 2012, 04:32:26 PM »

Okay Guys, I've been rummaging thru my parts bins, and I've found what I've been told is an Andrews "K" grind cam for a CB750. It's a good one, it came with a K0 head and 836cc pistons and barrels I bought on EBay a few years ago. I believe that the K grind cam is similar to Megacycle's 125/65. If you're not familiar with this cam, here's a link to the specs from Axl's site:

http://www.satanicmechanic.org/andrewscam.shtml

To help the auction along, I'll also pay the postage, (anywhere where in the world) so the lucky bidder will only pay the winning bid. Cheers, Terry.

voxonda · « **Reply #79 on:** January 04, 2012, 01:06:27 AM »

Good one Terry,

I'll start the bidding at 85USD.

Cheers mate,

Rob

Retro Rocket · « **Reply #80 on:** January 04, 2012, 01:12:59 AM »

I'll bid $95......

voxonda · « **Reply #81 on:** January 04, 2012, 07:02:30 AM »

Oh, you rascal you,

Ok up a tenner...........105USD. All for that great cause. Get well Brian!

Rob

Terry in Australia · « **Reply #82 on:** January 04, 2012, 04:11:59 PM »

Thanks guys, that's great. I'll let the auction run until midnight on the 14th, then I'll go dig something else out to auction off. Cheers, Terry.

sohc boy · « **Reply #83 on:** January 05, 2012, 02:13:19 AM »

..Terry .. damn !would like that cam to go with the R.C. pistons ,but the last of my play money just got eaten up by a malfuntion in my van

Terry in Australia · « **Reply #84 on:** January 05, 2012, 02:49:13 AM »

Ha ha, no worries mate, I'm sure it'll go to a good home. I think Russ Collins used these cams in his "Cobra" engines, but I could be wrong? This cam came with the RC 836CC pistons and rods that I'm running in my K1. I didn't use the cam because I'd just bought the Megacycle 125/75 cam, and used it basically, because I didn't know where to find the specs for the Andrews cam. Cheers, Terry.

Sam Green Racing · « **Reply #85 on:** January 05, 2012, 03:52:45 AM »

Quote from: voxonda on January 04, 2012, 07:02:30 AM

Oh, you rascal you,

Ok up a tenner...........105USD. All for that great cause. Get well Brian!

Rob

Be carefull guys, make sure your bid is in the same type of $. At $95, the Ausie one is nearly £1 more than the US one.

Sam.

Terry in Australia · « **Reply #86 on:** January 05, 2012, 04:17:41 AM »

Sorry Guys, I've only got an "Aussie dollar" key on my compuker, (the Aussie dollar is worth about 2 US cents more than the USD at the moment) but to make it easier, we'll assume that all bids are in US dollars, OK? Cheers, Terry.

mickey6 · « **Reply #87 on:** January 05, 2012, 05:08:27 AM »

hey scottly go ahead and run those rear set plates for auction again as my contribution to the cause. I'm gonna send Sam the amount that I won the auction, but I no longer actually need them as I decided to part out thhe project I was going to use them on. This way we save on shipping cost and time

Sam Green Racing · « **Reply #88 on:** January 05, 2012, 05:17:01 AM »

Nice one Mickey. When you send it, Click on personal and send as a gift in £ GB

to late.

Thanks Mickey, God bless you.

Sam.

mickey6 · « **Reply #89 on:** January 05, 2012, 05:23:58 AM »

Quote from: SamCB750A on January 05, 2012, 05:17:01 AM

Nice one Mickey. When you send it, Click on personal and send as a gift in £ GB to late.

Thanks Mickey, God bless you.

Sam.

Sorry bout that got in too much of a hurry

Sam Green Racing · « **Reply #90 on:** January 05, 2012, 05:52:35 AM »

JLeather · « **Reply #91 on:** January 05, 2012, 11:22:39 AM »

I got $120 for that cam. BTW Terry, I think the RC327 cam was in the Cobra motors, not the 315. It's a hot one, though, for sure.

voxonda · « **Reply #92 on:** January 05, 2012, 01:07:56 PM »

Ok, we got a fight,

, on our hands, another ten towards Brian. 130USD for the cam.

Terry in Australia · « **Reply #93 on:** January 05, 2012, 01:48:18 PM »

Well done Rob, and I think JL's right too. I've got three of those cams but there's lobe damage on two of them. (This one is fine though) I must take them to Wade camshafts here in Melbourne and get them welded up and re-ground so I can use one in my new engine. Cheers, Terry.

scottly · « **Reply #94 on:** January 05, 2012, 06:16:29 PM »

Quote from: mickey6 on January 05, 2012, 05:08:27 AM

hey scottly go ahead and run those rear set plates for auction again as my contribution to the cause. I'm gonna send Sam the amount that I won the auction, but I no longer actually need them as I decided to part out thhe project I was going to use them on. This way we save on shipping cost and time

Thankfully, I checked here before heading to the post office; I got the stuff boxed up yesterday, but decided to dig around more looking for the BSF bolts that thread into the frame tube clamps; found 3 of the 4.
If you are interested in the relay patch, you can apply what you have sent Sam to any bid you make.
Scott

mickey6 · « **Reply #95 on:** January 06, 2012, 03:07:22 AM »

Quote from: scottly on January 05, 2012, 06:16:29 PM

Quote from: mickey6 on January 05, 2012, 05:08:27 AM
hey scottly go ahead and run those rear set plates for auction again as my contribution to the cause. I'm gonna send Sam the amount that I won the auction, but I no longer actually need them as I decided to part out thhe project I was going to use them on. This way we save on shipping cost and time
Thankfully, I checked here before heading to the post office; I got the stuff boxed up yesterday, but decided to dig around more looking for the BSF bolts that thread into the frame tube clamps; found 3 of the 4.
If you are interested in the relay patch, you can apply what you have sent Sam to any bid you make.
Scott

thank you scottly. I would feel cheap if I were to apply what I sent Sam for the rear sets set up towards anything else lol... no matter how badly I want that patch as I kinda spaced ordering one when was planning my leg of the rally.

Scott what do ya say we start the bidding on that rear set stuff again.
Do I hear $20.

Sam Green Racing · « **Reply #96 on:** January 06, 2012, 07:31:30 AM »

OK.

Sam.

P.S. come on guys, help me out, I don't want these.

just getting the auction under way again.

Sam.

scottly · « **Reply #97 on:** January 06, 2012, 07:07:55 PM »

Quote from: mickey6 on January 06, 2012, 03:07:22 AM

thank you scottly. I would feel cheap if I were to apply what I sent Sam for the rear sets set up towards anything else lol... no matter how badly I want that patch as I kinda spaced ordering one when was planning my leg of the rally.

Hey, it'll still cost you another $15 just to make the minimum bid, which would be $15 more for Bear.

Hell, they were only about $8 to begin with. Remember, nort only had 100 made, as I recall, so this may be your last chance. Buy it, or I'll feel guilty!!!!

RAFster122s · « **Reply #98 on:** January 06, 2012, 07:37:50 PM »

Hey Scott, Why don't you post a "board" in this thread with the current bid and item so everyone knows where things are now.
That way they can sift through the chaff to get to the wheat and get and keep the ball rolling on the bidding. Posting an Auction board every so often would keep everyone on track...

Maybe in the format of:

(A) ITEM (B) DONATED BY (C) CURRENT BID (D) CURRENT HIGH BIDDER (E) CLOSING TIME

Just a made up example ...
(1A) Nort Rear sets (see post #96 for description)
(1B) Scottly
(1C) $20US
(1D) SAMCB750A
(1E) 10PM Jan 8th

Just a thought...
David

mickey6 · « **Reply #99 on:** January 06, 2012, 07:43:27 PM »

Quote from: scottly on January 06, 2012, 07:07:55 PM

Quote from: mickey6 on January 06, 2012, 03:07:22 AM

thank you scottly. I would feel cheap if I were to apply what I sent Sam for the rear sets set up towards anything else lol... no matter how badly I want that patch as I kinda spaced ordering one when was planning my leg of the rally.

Hey, it'll still cost you another $15 just to make the minimum bid, which would be $15 more for Bear. Hell, they were only about $8 to begin with. Remember, nort only had 100 made, as I recall, so this may be your last chance. Buy it, or I'll feel guilty!!!!

Ok Scott, consider my arm twisted

. I bid on the relay patch.

News:

Author Topic: Benefit Auction (Read 40097 times)