« previous next »
Pages: [1]   Go Down

Author Topic: Setting valves after rebuild  (Read 426 times)

0 Members and 1 Guest are viewing this topic.

Offline DavePhipps

  • Expert
  • ****
  • Posts: 1,150
  • Reading the entire Hi-Perf forum
    • Hillside Technology
Setting valves after rebuild
« on: April 15, 2012, 06:34:14 AM »
Got the top end together this week and ran into a snag, When I went to set the valve lash I rotated to the to 1-4 and found that there is a tappet loose on 1 and 4. The other tappets on 1 and 4 are tight.  How do I determine where to start?
Logged
Bikes:
90 FZR600 RA
74 CB550k
78 GL1000
72 CB500K
Pages: [1]   Go Up
« previous next »