« previous next »
Pages: [1]   Go Down

Author Topic: DIY breather hose  (Read 640 times)

0 Members and 1 Guest are viewing this topic.

Offline txterror

  • Hot Shot
  • ***
  • Posts: 263
DIY breather hose
« on: January 15, 2013, 01:33:35 pm »
Before i buy one, was wondering if anyone made their own Breather hoses. Or has seen it done somewhere. Im in need of both, one to air chamber and the one at bottom of air box
Logged
1975 cb400f

Offline cougar

  • Hot Shot
  • ***
  • Posts: 410
  • Stamping Ground, Kentucky U.S.A.
Re: DIY breather hose
« Reply #1 on: January 15, 2013, 06:19:03 pm »
LOL, not OEM but I'm just using standard automotive vacuum hose on mine but my bike is far from stock. Have one running from head to breadbox breather and one from the tranny to my oil tank. 1976 cb750F1    ...cougar...
Logged
I'm not prejudice, I'll weld anything that pays! Knowledge that is shared is Never Lost!!   Right is right, wrong is wrong! The truth is the truth and a lie is a lie! DEAL WITH IT ACCORDINGLY !!!   I HATE "DIAL-UP"

Offline bjbuchanan

  • Master
  • *****
  • Posts: 2,276
Re: DIY breather hose
« Reply #2 on: January 15, 2013, 07:20:53 pm »
I know this probably seems very ghetto but I used a stub piece of rubber hose and an old tshirt trimmed nicely so it doesn't look too trashy. You can't rly see it and its clean so it doesn't really draw the eye

My tranny is connected to the oil tank via a vacuum hose tho, no redneck engineering there
Logged
The dirty girl-1976 cb750k, Ebay 836, Tracy bodykit
Round top carbs w/ 38 pilots, middle needle position, airscrew 7/8ths out, 122 main jet
Stock airbox w/ drop in K&N, Hooker 4-1

Don't trust me alone with a claw hammer and some pliers
Pages: [1]   Go Up
« previous next »