Author Topic: 350F Forks  (Read 610 times)

0 Members and 1 Guest are viewing this topic.

Offline rokusek

  • Full Member
  • *
  • Posts: 68
350F Forks
« on: March 14, 2013, 01:37:39 PM »
Can anyone tell me if these will work for a CB350f, the dimensions are correct for the 350f 33mm X 22"

http://www.ebay.com/itm/200702064521?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

...thanks!

Offline camelman

  • Man... Myth... Legend
  • Master
  • *****
  • Posts: 1,899
Re: 350F Forks
« Reply #1 on: March 14, 2013, 06:25:09 PM »
You'd be chancing it unless you can figure out if the machining at the end of the tubes is the same. Look for 350f/400f/360t forks. They'll swap straight in. I might even have a spare set...just waiting to see if another forum member needs them.

The 500/360 forks are the same, just with slightly better internals than the 350f forks. They might be one CM longer, but that's no real issue.
1972 350f rider: sold
1972 350f/466f cafe: for sale
1977 CB400f cafe:sold
1975 CB400f rider: sold
1970 CB750 K0 complete bike: sold
2005 Triumph Sprint ST 1050 rider

We've got to cut it off... and then come down on rockets.  (quoted from: seven minutes of terror)

Offline rokusek

  • Full Member
  • *
  • Posts: 68
Re: 350F Forks
« Reply #2 on: March 14, 2013, 06:39:46 PM »
Thanks, today I took apart the fork and noticed that there are differences. The tubes I have rust and some pitting so they don't look to good...keep me updated if yours are available...thanks again!

Offline steam-powered man

  • Not the eggman, Not the walrus, I am the
  • Hot Shot
  • ***
  • Posts: 591
  • Where are you going? I was going to make Espresso
Re: 350F Forks
« Reply #3 on: March 14, 2013, 07:34:03 PM »
i have a set of cb350f fork tubes for sale.  rust on each, extending from 1/4 inch above the lower triple to 2 inches below the lower triple.  nasty below the triple can be hidden by fork boots.  area swept by seals is perfect.  have them posted at $24/pair, plus shipping.  pm if interested, will send pics.
bobp
searching for a dr350se

Offline rokusek

  • Full Member
  • *
  • Posts: 68
Re: 350F Forks
« Reply #4 on: March 15, 2013, 05:08:35 AM »
pm sent :)