« previous next »
Pages: [1]   Go Down

Author Topic: New oil pressure switch connector.  (Read 440 times)

0 Members and 2 Guests are viewing this topic.

Offline davidtime

  • Hot Shot
  • ***
  • Posts: 449
New oil pressure switch connector.
« on: July 05, 2013, 06:45:52 PM »
Does anyone know where to get the connector for the oil pressure switch on the CB550?
Logged

Offline dave500

  • Really Old Timer ...
  • *******
  • Posts: 17,054
  • WHAT?no gravy?
Re: New oil pressure switch connector.
« Reply #1 on: July 05, 2013, 11:22:38 PM »
its just an ordinary connector?a circular one,you could used a forked one,you could make one.
« Last Edit: July 05, 2013, 11:24:12 PM by dave500 »
Logged

Offline davidtime

  • Hot Shot
  • ***
  • Posts: 449
Re: New oil pressure switch connector.
« Reply #2 on: July 06, 2013, 08:23:36 AM »
Quote from: dave500 on July 05, 2013, 11:22:38 PM
its just an ordinary connector?a circular one,you could used a forked one,you could make one.

Thanks Dave
I guess I will just make one from my assortment. The one on it seemed like it held on nice and snug. The PO had the wire pinched in between the cover and the case and it broke off when I tried to disconnect it. Not much room on that wire to install a new connector to it.
Logged

Offline dave500

  • Really Old Timer ...
  • *******
  • Posts: 17,054
  • WHAT?no gravy?
Re: New oil pressure switch connector.
« Reply #3 on: July 06, 2013, 02:28:31 PM »
you might be able to solder it little longer,then shink tube over it?
Logged
Pages: [1]   Go Up
« previous next »