« previous next »
Pages: [1]   Go Down

Author Topic: WIRING A LED SPEEDOMETER  (Read 703 times)

0 Members and 2 Guests are viewing this topic.

Offline neilc

  • Hot Shot
  • ***
  • Posts: 477
  • old school biker,other bike is a 2003 vtx1800c
WIRING A LED SPEEDOMETER
« on: August 30, 2013, 10:40:50 AM »
DO I NEED TO DO ANYTHING SPECIAL TO WIRE A LED LIGHTED AFTERMARKET SPEEDOMETER I MIGHT GET FROM DIME CITY CYCLES( 2.5" WHITE  FACED 1:4 RATIO)
Logged

Offline Geeto67

  • A grumpy
  • Old Timer
  • ******
  • Posts: 2,823
Re: WIRING A LED SPEEDOMETER
« Reply #1 on: August 30, 2013, 11:59:22 AM »
yeah a different speedometer with a ratio of 2240:60.

for reference:
CB750 Speedo  2240:60  Tach 4:1
Logged
Maintenance Matters Most

Offline bjbuchanan

  • Master
  • *****
  • Posts: 2,276
Re: WIRING A LED SPEEDOMETER
« Reply #2 on: August 30, 2013, 01:55:17 PM »
Depends, do they specify that you won't need to use resistors on installation? Description usually says whether or not, I'm pretty sure that those are plug and play tho...
Logged
The dirty girl-1976 cb750k, Ebay 836, Tracy bodykit
Round top carbs w/ 38 pilots, middle needle position, airscrew 7/8ths out, 122 main jet
Stock airbox w/ drop in K&N, Hooker 4-1

Don't trust me alone with a claw hammer and some pliers

Offline neilc

  • Hot Shot
  • ***
  • Posts: 477
  • old school biker,other bike is a 2003 vtx1800c
Re: WIRING A LED SPEEDOMETER
« Reply #3 on: August 30, 2013, 03:03:02 PM »
ya, they sent me a email stating just pklug and go,no resistor needed
Logged
Pages: [1]   Go Up
« previous next »