Author Topic: CB500 Shifter Service Bulletin?  (Read 1866 times)

0 Members and 1 Guest are viewing this topic.

Offline puppytrax

  • Expert
  • ****
  • Posts: 1,059
CB500 Shifter Service Bulletin?
« on: September 08, 2013, 07:48:39 PM »
I am looking for a Honda Service Bulletin that would have gone out in 1971 or 1972...Concerning shifting problems with the 1971 CB500 Four...It would have announced a 'kit' that replaced certain parts to correct or minimize the problem...I
understand that the Service Bulletins previously posted here have all been taken down, so I'm asking for a link or a copy of the Bulletin involved.

I bought a CB500 Four back in 2006, and I'd like to see what serial numbers got the 'fix' from the factory (before the redesign that was reflected in CB550's), and how dealer-applied 'fixes' were identified...Maybe with a stamp somewhere that
would be obvious to a Honda mechanic...

Here's the story...Feel free to go on to something else, as this is rather long, and I did post a thread on it years ago...

I was stationed on Okinawa in 1971, and first saw the then-new CB500 Four in a Ryukuan cycle shop. I really liked it, and when I was discharged in Dec '71, I decided to get one ASAP. Getting settled took me a few months, but by about March/April '72 I had the money [about $1600 IIRC]. The local Honda dealer, Honda Village in Niagara Falls NY had several new unridden CB500's on the display floor. A salesman (co-owner it turned out) named "Whitey" showed me several floor models. I chose a Garnet Brown model. I installed a couple accessories to it, like a finned oil filter cover and a  triple-tree ignition switch mount.

I rode it cautiously for the first 500/750 break-in miles, and then felt ready to try it out. IIRC it would do 105mph top end. I rode it for about 6 weeks, and one day while leaving my GF's house, shifting from 1st to 2nd, the entire drive train
locked up completely. Caught me by surprise, and I barely kept it upright while skidding to a stop. Not very fast, maybe 10-15mph. I poked at the shift lever while rocking it back & forth, and finally got it into a gear. It started up normally,
and I drove away, thinking it was probably my fault.

About another 5 or 6 weeks later, it happened again. 1st to 2nd shift, everything locked up. But this time I had my fingers on the clutch lever and disengaged the clutch, and rolled to a stop, engine still running. I was once again able to shift up
& down until I got a gear, and was then able to shift normally and ride it home.

I subscribed to a motorcycle newspaper/tabloid thingy back then (called "Cycle News" I think), and shortly after my 2nd shift episode, I read of a problem with 500 Four shifters/transmissions, where they selected a 'false neutral', and that dealers
had been alerted about this problem and a dealer-installed 'kit' to fix it, under warranty. The next day, I took my 500 Four to the dealer and explained what happened. "Whitey" told me it only applied to 1971 500 Fours, and mine was a 1972 model and already had the new parts installed at the factory. I was told my problem was not covered under warranty and that if I wanted my 500 Four torn down for inspection, it would cost me $75 [IIRC in 1972] just to disassemble it. I didn't have that kind of money right then (I was back in college), so it never got 'dealer torn down/inspected'.

About a month later, it happened again - but this time going from 2nd to 3rd, and I was doing ~35mph...Again I pulled in the clutch, and drifted to the shoulder of the road. In all this time, I had not put a lot of miles on it; no trips, no daily commuting; just pleasure rides.

Fall was here, and I put the Honda away for the Winter (I'm just North of Buffalo NY, snow capital of the world). Spring of 1973 I sold the cycle. I didn't trust it anymore. I bought a Triumph Daytona [500 dual-carb twin] and later sold that &
upgraded to a 650 Triumph Bonneville.

About a year later, I got a letter from a law firm inviting me to join a class action lawsuit against American Honda Motor Company. It stated that my 500 Four VIN was identified as one that the lawsuit alleged was involved in a fraudulent scheme by AHMC to re-register certain unsold 1971 models as 1972's. AHMC had asked dealers to send in the VINs of unsold cycles and AHMC would send an 'updated' Certificate of Origin stating they were 1972 models. Since mine was one of the VINs identified, I joined the lawsuit. About nine months later, I was informed by letter that AHMC had settled out of court, and I received a check for [IIRC] $65, which was explained as the difference between resale value of a '71 vs a '72.

That was the end of my involvement with that particular Honda 500 Four, but I've always felt I had unfinished business with that model. So when a 500 cropped up in 2006 (no 550's available here at that time), I bought it.

I'm hoping this one has the 'fix' already applied to it, either by the factory or a dealer. I'm hoping the Service Bulletin identified what VINs were affected, and how the 'fix' was marked.

Thank you all for your patience!
« Last Edit: September 09, 2013, 06:45:07 AM by puppytrax »
...stock 1972 CB500 '500 Four' undergoing re-assembly...
...Stock 1972 CL450 'Scrambler' also being re-assembled...

Offline dave500

  • Really Old Timer ...
  • *******
  • Posts: 17,022
  • WHAT?no gravy?
Re: CB500 Shifter Service Bulletin?
« Reply #1 on: September 08, 2013, 08:20:30 PM »
the early shift drum was located by a steel ball in a vee groove,this got replaced with a ferrule type design,the drum would drift sideways,this was further improved on tbe 550 with no locating devise but a pressed on bearing

Offline puppytrax

  • Expert
  • ****
  • Posts: 1,059
Re: CB500 Shifter Service Bulletin?
« Reply #2 on: September 08, 2013, 09:38:54 PM »
There was actually a lot more to it than that...Member 'BryanJ' had emailed me the Service Bulletin # 4 and I found it in my archives...

Here's an excerpt...

BTW: The 'kit' was still available back in 2007, for $155...   :o
...stock 1972 CB500 '500 Four' undergoing re-assembly...
...Stock 1972 CL450 'Scrambler' also being re-assembled...

Offline dave500

  • Really Old Timer ...
  • *******
  • Posts: 17,022
  • WHAT?no gravy?
Re: CB500 Shifter Service Bulletin?
« Reply #3 on: September 08, 2013, 11:33:57 PM »
the parts in the upper right and lower left are the updated parts,ive seen the ball type without the old drum stopper.

Offline Deltarider

  • Really Old Timer ...
  • *******
  • Posts: 8,132
  • ... but some animals are more equal than others.
Re: CB500 Shifter Service Bulletin?
« Reply #4 on: September 08, 2013, 11:36:52 PM »
You mean the Service Bulletins #4 and #9. Problems must have occurred mainly in U.S as they had the early 500. As far as the Europe continent I have no indications there were problems. We must have had the modified models.
« Last Edit: September 08, 2013, 11:53:33 PM by Deltarider »
CB500K2-ED Excel black
"There is enough for everyone's need but not enough for anybody's greed."

Offline Deltarider

  • Really Old Timer ...
  • *******
  • Posts: 8,132
  • ... but some animals are more equal than others.
Re: CB500 Shifter Service Bulletin?
« Reply #5 on: September 08, 2013, 11:38:32 PM »
And here's #4.
BTW, I have the other Service Bulletins as well. If someone can explain me how and where, I could upload them.
« Last Edit: September 08, 2013, 11:46:16 PM by Deltarider »
CB500K2-ED Excel black
"There is enough for everyone's need but not enough for anybody's greed."

Offline puppytrax

  • Expert
  • ****
  • Posts: 1,059
Re: CB500 Shifter Service Bulletin?
« Reply #6 on: September 09, 2013, 06:38:36 AM »
Thank You for the help gentlemen! I was able to locate Honda SB's 1 - 9. My second 500 Four is CB500E-2124603 so it should have all the 'upgraded' parts listed in SD-#4.

And here's #4.
BTW, I have the other Service Bulletins as well. If someone can explain me how and where, I could upload them.

I would ask a moderator [Znabb] and start a new thread with the SD's as attachments and let him 'sticky' it.
« Last Edit: September 09, 2013, 06:55:06 AM by puppytrax »
...stock 1972 CB500 '500 Four' undergoing re-assembly...
...Stock 1972 CL450 'Scrambler' also being re-assembled...

Offline puppytrax

  • Expert
  • ****
  • Posts: 1,059
Re: CB500 Shifter Service Bulletin?
« Reply #7 on: September 09, 2013, 06:49:44 AM »
BTW, during/after the class action lawsuit, I corresponded with a couple other CB500 owners who were in the lawsuit, and their problems were the 'false neutral' variety. I seemed to be the only one with lock-up problems.     :-\
...stock 1972 CB500 '500 Four' undergoing re-assembly...
...Stock 1972 CL450 'Scrambler' also being re-assembled...

Offline Lost and Confused

  • Bob
  • Enthusiast
  • **
  • Posts: 209
  • An old fart !!
Re: CB500 Shifter Service Bulletin?
« Reply #8 on: September 10, 2013, 06:46:23 AM »
Hello. I'm glad you found the info you needed. On another note, I live in North Tonawanda and am looking for someone to ride with. If so inclined, shoot me a note. bobpapin@Gmail.com


Thanks, Bob