« previous next »
Pages: [1]   Go Down

Author Topic: Transmission shaft slot  (Read 1377 times)

0 Members and 1 Guest are viewing this topic.

Offline cj8990

  • Full Member
  • *
  • Posts: 56
Transmission shaft slot
« on: June 24, 2016, 06:33:15 PM »
Assembling cb550 motor now.. One of the Trans shafts has a cut out on the end cage that holds the needle rollers.

Does it matter the orientation of this cut out on the journal of the case?
Logged

Offline cj8990

  • Full Member
  • *
  • Posts: 56
Re: Transmission shaft slot
« Reply #1 on: June 25, 2016, 01:52:06 AM »
It can be seen here in the box labeled 15.

Anyone know if the orientation matters?
Logged

Offline kmb69

  • Master
  • *****
  • Posts: 2,041
Re: Transmission shaft slot
« Reply #2 on: June 25, 2016, 06:25:21 AM »
Quote from: cj8990 on June 25, 2016, 01:52:06 AM
It can be seen here in the box labeled 15.

Anyone know if the orientation matters?

Yes. Item 16 is a dowel pin that orients the bearing outer to the case. Should have matching holes in the bearing outer and the case.

Logged
Pages: [1]   Go Up
« previous next »