Final drive seal on cb750K5.
First seal didn’t seat right was sticking out too far. Saw this Hackaweek video and realized I didn’t have to start over and pull the cases back apart. I tried with a new seal without any silicone sealant, but I did use a 2” pipe and cap, like he does in the video. The seal bunched up around the edges, so I ordered a new one.
He mentions using a silicone sealant at the 3’40” mark in the video to help the seal slide in. Any recommendations for high temp silicone sealant I should use for this application? I have threebond 1184, which is silicone, but it sets up pretty quick.