Topic: How do you get kickstart shaft from the case

[70CB750]

What the title says, the kickstart assembly is the last thing to get out od the bottom case of CB750 for thorough cleaning.

[69cb750]

Pull out the hollow pin with small vise grips, be careful.
I prefer to clean without removing pin, bit of a pain to remove and install pin.

[Don R]

 I give it some lube, squeeze the roll pin with vise grips, and turn it while prying up a little on the grips . Rotating the pin back and forth seems to work best for me. The vice grips will slip off 30 or 40 times. 
 I did one yesterday.

[70CB750]

The pin was actually already out, rubber mallet drove it out, i just wasnt sure.

Thank you, guys.

[HondaMan]

I give it some lube, squeeze the roll pin with vise grips, and turn it while prying up a little on the grips . Rotating the pin back and forth seems to work best for me. The vice grips will slip off 30 or 40 times. 
 I did one yesterday.

I just did that today. This one must be weak, it only took 22 tries...

[Don R]

 I did another one too, same deal.  It was in a broken and lonely lower case by but it had the kicker and most of a trans in it. Will be beer cans soon.