Author Topic: Hi all - gotta carb question: steady throttle hesitation cause?  (Read 1454 times)

0 Members and 1 Guest are viewing this topic.

Offline steam-powered man

  • Not the eggman, Not the walrus, I am the
  • Hot Shot
  • ***
  • Posts: 591
  • Where are you going? I was going to make Espresso
hey all,
my other bike is a 2000 husky te-610e, a single cylinder enduro bike.  about 51hp, about 340lbs, 6 speed, e-start, a freaking blast to ride.  had it for a few months now, has only 1450miles on it, and a beaut!  po says he had a dealer put a jet kit in, but can't remember the details so - no help there.

figured a carb is a carb, thought i'd ask here:  bike pulls strong as hell up to rev limit, lotsa power anytime, everywhere.  will spin the rear tire on a dirt road for as long as you like, from any speed.  no popping on closed throttle, plug looks great/new after 400miles.

steady throttle at about 3k (redline is 8K) results in minor but annoying hesitation.  no noise, just hesitates a bit. 

last three tanks had correct amount of seafoam additive w/no effect.  am thinking float level is wrong, but am not sure. 

this site is full of carb folks, so thought i'd give it a shot.  all guesses welcome.  thanks!
bobp 
searching for a dr350se