« previous next »
Pages: [1]   Go Down

Author Topic: cylinder head milling 75 750 f  (Read 717 times)

0 Members and 1 Guest are viewing this topic.

750mikeb

  • Guest
cylinder head milling 75 750 f
« on: October 10, 2008, 05:03:47 AM »
I was wondering how much I can mill off my cylinder head it is being reground is 10 thousandths too much? I would like to straighten it and increase the compression also thanks   mike
Logged

Offline MRieck

  • Really Old Timer ...
  • *******
  • Posts: 10,596
  • Big ideas....
Re: cylinder head milling 75 750 f
« Reply #1 on: October 10, 2008, 05:32:17 AM »
Quote from: 750mikeb on October 10, 2008, 05:03:47 AM
I was wondering how much I can mill off my cylinder head it is being reground is 10 thousandths too much? I would like to straighten it and increase the compression also thanks   mike
.010 is not to much. I'd recommend you install a slotted cam chain sprocket too.
Logged
Owner of the "Million Dollar CB"

Offline johnny_from_bel

  • Enthusiast
  • **
  • Posts: 154
  • Member #158
Re: cylinder head milling 75 750 f
« Reply #2 on: October 10, 2008, 06:25:25 AM »
The manual says to rework the head if it is more than 0.25 mm wraped (diff between highesd and lowesd point)
So I take you can safely shave off 0.25 mm
Logged
Pages: [1]   Go Up
« previous next »