« previous next »
Pages: [1]   Go Down

Author Topic: LED tail light help  (Read 660 times)

0 Members and 1 Guest are viewing this topic.

Offline socalenduro

  • Hot Shot
  • ***
  • Posts: 611
LED tail light help
« on: May 04, 2010, 02:47:31 PM »
I have a LED tail/brake light (3 wire) that im trying to hook up.
Will i need a resistor or anything? Or is that only for turn signals?

Is there a way to tell using volt meter?
Logged

Offline Duke McDukiedook

  • Space Force 6 Star General
  • Really Old Timer ...
  • *******
  • Posts: 12,688
  • Wish? Did somebody say wish?
Re: LED tail light help
« Reply #1 on: May 04, 2010, 02:49:40 PM »
Sounds like it is a plug-n-play unit.

Plug it in and see if it works, sounds like it probably already wired with the proper resistors already.
Logged
"Well, Mr. Carpetbagger. We got somethin' in this territory called the Missouri boat ride."   Josey Wales

"It's Baltimore, gentlemen. The gods will not save you." Ervin Burrell

CB750 K3 crat | (2) 1986 VFR750F

Offline socalenduro

  • Hot Shot
  • ***
  • Posts: 611
Re: LED tail light help
« Reply #2 on: May 04, 2010, 02:57:54 PM »
the response from the ebay vender......was that it does not have resistors in the unit....
and that i would need to check my bikes wiring to tell.....

but arent there different types of LEDs?
Im worried about voltage right?
Logged

Offline cb750k77

  • Enthusiast
  • **
  • Posts: 165
Re: LED tail light help
« Reply #3 on: May 04, 2010, 03:00:02 PM »
resistors are only for turn signal
Logged
CB750k77 rebuilt (almost)
Pages: [1]   Go Up
« previous next »