Topic: Pamco ignition connections

[gregripko]

Notice there isn't bullet connections on the green wires that connect to the blue and yellow wires.... I'm not too familiar with electrical connections on these bikes but where can I get bullet connectors (what size) and do they have to be sautered?

[Scott S]

 You can get bullet connectors at any NAPA, Pep Boys, Wal-Mart, etc. You will also need a crimping tool.
 They don't have to be soldered. Be sure to get the correct size connectors...blue should work, but you may have to fold the thin gauge wire over a couple of times. You'll also need a connector for the ground wire. I use the kind that have a loop and ground it to the frame.

[gregripko]

Thank you!....do you know what size the bullets are by chance? I've heard 3.5mm and 4mm are the most common but i dont want to buy the wrong ones.....

[tomkimberly]

Thank you!....do you know what size the bullets are by chance? I've heard 3.5mm and 4mm are the most common but i dont want to buy the wrong ones.....

If you can come to Orange, near the 55 and 91 freeways, I can do it for you, I have a complete vintage connection kit.

PM me.

Tom

[gregripko]

Pm sent Ty!

[tomkimberly]

Pm sent Ty!

Reply sent.

BTW FWIW, to those  who know I have been out on a medical LOA, I went back to work today!     364 days off, today was not that bad....