I recently purchased a CB750/520 drive sprocket from "Cycle X". No complaints on the product !! It's just that for the motor I'm using (cb400F) it (the sprocket) is to thick to allow the locking ring to be used. The sprocket for the 400F is .348" thick and the cb750/520 sprocket is .5 thick. What I need is someone who can machine .076" from each side (of the RAISED AREA ONLY in the pic) of the sprocket ! Not trying to be a smart*ss but this Must be milled/machined flat as it sits against the sprocket shaft in the inside. Can anyone here do this for a Reasonable price? Give me a shout here or P.M. me, either way is cool! Thanks, ...cougar... P.S. I'm posting here as well 'cause some folks might not see the "Services Wanted" listing. Pic of sprocket on "Services Wanted ", located here.
http://forums.sohc4.net/index.php?topic=140438.0
