Topic: Who has replaced rear wheel bearings - CB500?

[jmelche2]

I'm replacing the original bearings in my 1972 CB500.  I can't seem to figure out the tabs used to keep the spacers positioned when you remove the axle.  They got slightly mangled when I removed the bearings and I need some advice as to the proper positioning of the tabs (see my attached photos).  If anybody has a photo, that would be very helpful.

Thanks for your help!

[MickB]

Looks OK to me and I've replaced bearings on front and rear wheels on a "72 CB500 and I believe the 3 prongs are to rest against the centre race of the bearing

[Whaleman]

I always open those double sealed bearings and change the grease. They come with a small amount of grease because they are also used in electric motors that turn 1600 RPM. We need more wheel bearing type grease for lower RPM and higher loads. Dan

[MickB]

It's funny as I was advised by a mechanic leave them as they have been pre-packed with grease and they'll be ok.
Sometimes it's hard to figure out who's right.

[MickB]

Thanks Cal