Topic: clogged fuel tank crossovers CB350, creative solutions asked for

[754]

I an thinking, the end of the speedo cable, did you sharpen it, make it more drill like, or perhaps like a spade drill ? So it can actually cut..
Get the part to the corner with a drill...
 I am thinking if you had a thick piece of  copper wire, sharpened.. About 1/2 the hole diameter...it may start bending while cutting, and follow around the corner. Turn slowly.

[strynboen]

the tire is korrekt mounted for a rear tire...vhen used as front tire..it need to run vith the arow..oh somone vas there befor mee..

[grcamna2]

I an thinking, the end of the speedo cable, did you sharpen it, make it more drill like, or perhaps like a spade drill ? So it can actually cut..
Get the part to the corner with a drill...
 I am thinking if you had a thick piece of  copper wire, sharpened.. About 1/2 the hole diameter...it may start bending while cutting, and follow around the corner. Turn slowly.

I know that cable 'inner' is strong,possibly use a large dia. cable 'inner' from another application like an automobile clutch cable of the correct dia. to fit inside that bend and maybe solder the end of it first..

[MoMo]

The speedo cable had a rounded point to the end, in combination with the MEK solution it worked.  I was thinking of sharpening it but it worked as is, probably would have been quicker if sharpened.  Most likely attempting to sharpen a twisted cable would have frayed it.


  Plans for painting the Fuglyone to follow....Larry