« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: 1977 CB550K running issues - seeking help  (Read 4095 times)

0 Members and 1 Guest are viewing this topic.

Offline Can550

  • Expert
  • ****
  • Posts: 783
Re: 1977 CB550K running issues - seeking help
« Reply #25 on: October 01, 2017, 07:55:38 AM »
When connected Morgan carbtune, all 4 tube gauges sit at the bottom unless RPM go above 2000-2500
All boots clamps are tight, new O rings in manifolds
Is it a symptom of air leak ?
Where do I start as have pulled carbs out about 6 times and tired now


Sent from my iPhone using Tapatalk
Logged

Offline Can550

  • Expert
  • ****
  • Posts: 783
1977 CB550K running issues - seeking help
« Reply #26 on: October 01, 2017, 07:56:39 AM »
Quote from: calj737 on September 30, 2017, 04:38:21 PM
Check the advancer mechanism to insure it returns from full advance.
Pulled it out, cleaned it and put back on. It was in correct order of installation


Sent from my iPhone using Tapatalk
« Last Edit: October 01, 2017, 08:52:38 AM by Can550 »
Logged

Offline Can550

  • Expert
  • ****
  • Posts: 783
Re: 1977 CB550K running issues - seeking help
« Reply #27 on: October 01, 2017, 06:00:45 PM »
The moment I rev, it dies


Sent from my iPhone using Tapatalk
Logged

Offline Can550

  • Expert
  • ****
  • Posts: 783
Re: 1977 CB550K running issues - seeking help
« Reply #28 on: October 02, 2017, 07:45:46 PM »
Replaced intake insulators, timed it again, camshaft tensioner, new plugs caps, checked oil level and right away fired up. Synced and smooth.
Thanks everyone for guiding and helping


Sent from my iPhone using Tapatalk
Logged
Pages: 1 [2]  All   Go Up
« previous next »