« previous next »
Pages: [1]   Go Down

Author Topic: Turn signal question  (Read 858 times)

0 Members and 1 Guest are viewing this topic.

Offline Coredozer19

  • Enthusiast
  • **
  • Posts: 154
Turn signal question
« on: May 16, 2018, 06:22:53 PM »
1973 Honda CB350F. I got 4 new indicators. The ones I got have 3 wires. And the old ones only have two. Could I run a wire from the low beam feed to the front signals and run a wire from the brake running  light feed to make these running indicators operational?

Biggest question is. When the high beam is turned on does the low beam stop recieving voltage.

And when the brake is applied does the running light feed to the brake light stop or does it still receive voltage
Logged
1973 Honda CB350F

Offline spotty

  • Master
  • *****
  • Posts: 2,117
  • cb750....for when a Vmax is just too much bike
    • spottys world of vmaxes and great danes
Re: Turn signal question
« Reply #1 on: May 16, 2018, 07:15:00 PM »
yes, high beam will turn off low beam

tail light will still run with brake light operating
Logged
i blame Terry

Offline Coredozer19

  • Enthusiast
  • **
  • Posts: 154
Re: Turn signal question
« Reply #2 on: May 16, 2018, 07:30:55 PM »
Okay so I should run all my running indicators off of the tail light.
Logged
1973 Honda CB350F

Offline Mantree

  • Hot Shot
  • ***
  • Posts: 595
Re: Turn signal question
« Reply #3 on: May 16, 2018, 08:14:26 PM »
Are they amber or red?  You can't have amber runing lights on the rear of the vehical.

Sent from my SM-G930V using Tapatalk

Logged
Pages: [1]   Go Up
« previous next »