« previous next »
Pages: [1]   Go Down

Author Topic: Best solution for nuts & bolts finish on 70’ 750?  (Read 995 times)

0 Members and 1 Guest are viewing this topic.

Offline slyguy

  • Enthusiast
  • **
  • Posts: 124
Best solution for nuts & bolts finish on 70’ 750?
« on: September 02, 2024, 06:58:53 PM »
I’ve cleaned the engine mounting & frame related hardware in the hypersonic. Not sure if original finish is/was cadmium, zinc and/or ? What do some of you guys do? I know there’s different finishes for the different hardware locations, just trying to keep chipping away! 😵‍💫
Logged

Offline 69cb750

  • Expert
  • ****
  • Posts: 1,245
Re: Best solution for nuts & bolts finish on 70’ 750?
« Reply #1 on: September 03, 2024, 04:04:38 AM »
Most of the nuts, bolts, washers were zinc.
A few were chrome, shock nuts and bolts, exhaust clamp bolts, top tree bolts.
Logged
Pages: [1]   Go Up
« previous next »