« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Looks like I need one last piece for my dual disc conversion  (Read 7276 times)

0 Members and 1 Guest are viewing this topic.

Offline MCRider

  • Such is the life of a
  • Really Old Timer ...
  • *******
  • Posts: 14,376
  • Today's Lesson: One good turn deserves another.
Re: Looks like I need one last piece for my dual disc conversion
« Reply #25 on: November 09, 2008, 04:11:09 pm »
Quote from: Iggy on November 09, 2008, 12:27:51 pm
Cross posting this from my project thread but if anyone will know it's probably you guys   ;)

I've modified my speedo drive plate using a Dremel (love that thing) and there's a bit of slop when fitted to the hub; maybe an 1/8 inch side to side. Is that how it's supposed to be or do I need to trim the diameter of the plate and bend the tangs down instead of just trimming the bell and leaving the bits that form the tangs? Pic attached and thanks!

That looks good, but will it fit inside the disk? I was thinking you had to reduce the overall diameter and bend tangs down?
Logged
Ride Safe:
Ron
1988 NT650 HawkGT;  1978 CB400 Hawk;  1975 CB750F -Free Bird; 1968 CB77 Super Hawk -Ticker;  Phaedrus 1972 CB750K2- Build Thread
"Sometimes the light's all shining on me, other times I can barely see, lately it appears to me, what a long, strange trip its been."

Offline ev0lve

  • Master
  • *****
  • Posts: 1,930
Re: Looks like I need one last piece for my dual disc conversion
« Reply #26 on: November 09, 2008, 04:38:13 pm »
I didn't do a dry fit yet so it'll be this weekend before I can get back to it. I'll give it a go and post back.
Logged
Pages: 1 [2]  All   Go Up
« previous next »