« previous next »
Pages: [1]   Go Down

Author Topic: Billet rear hub for GS1150  (Read 1316 times)

0 Members and 1 Guest are viewing this topic.

Offline 1080

  • Hot Shot
  • ***
  • Posts: 414
Billet rear hub for GS1150
« on: September 16, 2009, 08:04:05 PM »
On my '84 Suzuki 1150 Dragbike the stock hub( wheel from a Gsxr-1100 '86 or '87 ) could not take the hard launches I was giving it. Cracks would show up again ( machined once before).

754 machined this nice piece for me.
Logged

Offline crazypj

  • I'm brill, me
  • Old Timer
  • ******
  • Posts: 4,467
  • first 100,000 miles. 1977 CB550F
Re: Billet rear hub for GS1150
« Reply #1 on: September 18, 2009, 06:11:27 PM »
Nice parts,
 Nice bike too.
 I likes the GSX1100/1150 (as far as I know, all the 16valve motors were GSX, except in USA where it was GS ?)
 Is it still 1150?

PJ
Logged
I fake being smart pretty good
'you can take my word for it or argue until you find out I'm right'

Offline 1080

  • Hot Shot
  • ***
  • Posts: 414
Re: Billet rear hub for GS1150
« Reply #2 on: September 19, 2009, 10:16:24 AM »
Yes it is a GS1150EF.
The stock back wheel on the GS1150 is 17 x 3.00 which you can not run a slick, so using a later wheel off a GSX ( 18 x 4.00 ) allows me to run a slick.

And it looks close to the original mag.

The engine is still a 1150 with a ported head and better valve springs and retainers.

I also run a Barnet clutch and do manual shifting.
Logged
Pages: [1]   Go Up
« previous next »