« previous next »
Pages: [1]   Go Down

Author Topic: What size is the adjusting sync nut on carbs?  (Read 752 times)

0 Members and 1 Guest are viewing this topic.

Offline Really?

  • I've come to the conclusion that I AM a
  • Really Old Timer ...
  • *******
  • Posts: 5,276
What size is the adjusting sync nut on carbs?
« on: May 24, 2010, 12:17:38 PM »
Ok, i bought a MotionPro CarbSync.  Waste of money.

Looking at the CarbTune since the Euro is in my favor - http://www.carbtune.com/  
 Hearing about $80 shipped.

See this sync nut/screw tool and an wondering what size it is - http://www.carbtune.co.uk/carbtool.html - It says it is 8mm.  What size are the four for the k5?  If it is the right size, have y'all used this and is it worth it?  I have not synced the carbs yet.
Logged
I don't have a motorcycle, sold it ('85 Yamaha Venture Royale).  Haven't had a CB750 for over 40 years.

The Wife's Bike - 750K5
The Kid's Bike - 750K3

Offline Duke McDukiedook

  • Space Force 6 Star General
  • Really Old Timer ...
  • *******
  • Posts: 12,690
  • Wish? Did somebody say wish?
Re: What size is the adjusting sync nut on carbs?
« Reply #1 on: May 24, 2010, 01:14:41 PM »
I found that adjusting the slide height for synching was done easiest with bicycle cone wrenches for bicycle hubs.
« Last Edit: May 24, 2010, 01:31:21 PM by Dukiedook »
Logged
"Well, Mr. Carpetbagger. We got somethin' in this territory called the Missouri boat ride."   Josey Wales

"It's Baltimore, gentlemen. The gods will not save you." Ervin Burrell

CB750 K3 crat | (2) 1986 VFR750F
Pages: [1]   Go Up
« previous next »