« previous next »
Pages: [1]   Go Down

Author Topic: Cylinder base orings  (Read 463 times)

0 Members and 1 Guest are viewing this topic.

Offline mrrch

  • Hot Shot
  • ***
  • Posts: 652
Cylinder base orings
« on: July 05, 2010, 02:32:50 PM »
In fitting my piston & rings into my cylinder on my 76 CB750 engine I did not notice the cylinder base orings if they went into place. Should I loose sleep over it? or pull the cylinder(head is not on yet)
Logged
my build

1977 CB750K WITH 1976 CB750F ENGINE

Offline Alan F.

  • We remember the Night Rider, and we know who you are.
  • Really Old Timer ...
  • *******
  • Posts: 7,361
Re: Cylinder base orings
« Reply #1 on: July 05, 2010, 02:55:34 PM »
yup, you could have a leaky mess without them in place. Good on you for catching it before the head went on.
-Alan
Logged

Offline mrrch

  • Hot Shot
  • ***
  • Posts: 652
Re: Cylinder base orings
« Reply #2 on: July 06, 2010, 08:46:26 AM »
It bothered me too much so this morning I pulled the jug and reseated the orings and reinstalled the cylinder(rings were MUCH easier this time to get onto the cylinders)
Logged
my build

1977 CB750K WITH 1976 CB750F ENGINE
Pages: [1]   Go Up
« previous next »