« previous next »
Pages: [1]   Go Down

Author Topic: Header question  (Read 589 times)

0 Members and 1 Guest are viewing this topic.

Offline ejc2g

  • Full Member
  • *
  • Posts: 19
Header question
« on: August 05, 2011, 01:24:57 PM »
Does anyone know if a stock 4-1 header from a 78 CB750F will fit on a 74 CB750K?  I have an extra header and was going to put it on my brothers bike since he doesn't like the 4-2.  Just needed to know if I will run into anything special.  The clamps seems to be different.

Thanks for the help.
Logged

KingCustomCycles.com

  • Guest
Re: Header question
« Reply #1 on: August 05, 2011, 01:28:43 PM »
The dimensions are the same, the clamps come in three flavors, spigots with one tightening bolt, Short spacers, long spacers, with studs sticking out of the engine for nuts.  The good news is it will bolt up with the proper spacers. A custom rear mount clamp to the footpeg or frame may be necessary.
Logged

Offline ejc2g

  • Full Member
  • *
  • Posts: 19
Re: Header question
« Reply #2 on: August 06, 2011, 07:53:46 PM »
Thanks!
Logged

Offline ejc2g

  • Full Member
  • *
  • Posts: 19
Re: Header question
« Reply #3 on: August 23, 2011, 01:22:59 PM »
Where would I obtain the spacers?  Been looking around, but I can't find the right item.

Logged
Pages: [1]   Go Up
« previous next »