« previous next »
Pages: [1]   Go Down

Author Topic: CB750 racing Arhma  (Read 1571 times)

0 Members and 1 Guest are viewing this topic.

4club

  • Guest
CB750 racing Arhma
« on: August 24, 2011, 07:08:48 pm »
I'm prepping my 76' cb750 F for the ARHMA race at Miller. I am removing the stator and using a thinner cover for clearance. What should I do to make sure everything is ok in terms of the crank end?
Thanks.
« Last Edit: August 24, 2011, 07:39:43 pm by 4club »
Logged

Offline Sam Green Racing

  • Moderator
  • Really Old Timer ...
  • *****
  • Posts: 16,068
  • I REALLY? hate black rims.
Re: CB750 racing Arhma
« Reply #1 on: August 25, 2011, 12:52:37 am »
Welcome 4club. It depends what you have in there. If you have removed the starter gear, there will be a oil hole on the crank that will need blocking up.
I seem to remember that oil can still get into the cover so you will need to block off the starter motor hole and where the wire loom goes through the cover if you have no generator in there.
More pics please. ;D ;D ;D

Sam. ;)

Logged
C95 sprint bike.
CB95 hybrid race bike
CB95 race bike
CB92
RS 175. sprint/land speed bike
JMR Racing CB750A street ET drag bike

Offline lucky

  • Really Old Timer ...
  • *******
  • Posts: 6,717
Re: CB750 racing Arhma
« Reply #2 on: September 09, 2011, 03:37:27 pm »
Well there is an opportunity for a machinist.
 Make a plug for the CB750 starter hole and sell it.
I have seen many CB750 riders ask for them.
Logged
Pages: [1]   Go Up
« previous next »