« previous next »
Pages: [1]   Go Down

Author Topic: 1976 k crank pin bearings  (Read 949 times)

0 Members and 1 Guest are viewing this topic.

Offline bomorr

  • Enthusiast
  • **
  • Posts: 106
    • sohc/4
1976 k crank pin bearings
« on: May 14, 2017, 02:59:41 PM »
After tearing my motor apart I am trying to determine what bearings I need to use when I rebuild it. I've done the table crank/ case and I know what it had originally but before I order $200 in bearings I want to make sure I have the right ones. After double checking my crank pins I measure a few of them at 35.095. This is way below anything on thr tables I see. Do I need to start looking at a replacement crank?

Sent from my SM-G950U using Tapatalk

Logged

Offline 754

  • Really Old Timer ...
  • *******
  • Posts: 29,046
Re: 1976 k crank pin bearings
« Reply #1 on: May 14, 2017, 03:08:47 PM »
What are you measuring with? I would not trust a caliper. Micrometer needs to be checked with a standard.
Logged
Maker of the WELDLESS 750 Frame Kit
dodogas99@gmail.com
Kelowna B.C.       Canada

My next bike will be a ..ANFOB.....

It's All part of the ADVENTURE...

73 836cc.. Green, had it for 3 decades!!
Lost quite a few CB 750's along the way

Offline bomorr

  • Enthusiast
  • **
  • Posts: 106
    • sohc/4
Re: 1976 k crank pin bearings
« Reply #2 on: May 14, 2017, 03:14:37 PM »
Yea I am using a caliper, my micrometer set is still on its way

Sent from my SM-G950U using Tapatalk

Logged

Offline BPellerine

  • Master
  • *****
  • Posts: 2,221
Re: 1976 k crank pin bearings
« Reply #3 on: May 14, 2017, 05:32:39 PM »
did you plastigauge them,you can just buy,one set of say green and brown and see where you are instead of buying all at once.bill
Logged
1978 CB 750K ard and webers
another anfob

Offline bomorr

  • Enthusiast
  • **
  • Posts: 106
    • sohc/4
Re: 1976 k crank pin bearings
« Reply #4 on: May 14, 2017, 06:41:47 PM »
Haven't done any plastigauge yet either, I'm picking up some sleeves tomorrow. So I can gauge where I'm at with the  Current bearings that were in the bike

Sent from my SM-G950U using Tapatalk

Logged

Offline bomorr

  • Enthusiast
  • **
  • Posts: 106
    • sohc/4
Re: 1976 k crank pin bearings
« Reply #5 on: May 15, 2017, 02:16:56 PM »
Ok just went through my crank pins again and they consistently get 35.9918 or 1.417". For a minute there I thought I was going to have to get a new crank! So I should be able to go green  bearings and double check with plastigauge

Sent from my SM-G950U using Tapatalk

Logged
Pages: [1]   Go Up
« previous next »