It's been a bit since I've posted any updates. I wanted to show the progress I've made over the last few weeks.
I picked up a new headlight and it's a little smaller than stock. I'm going for a little cleaner look up front. It's also a bottom mount headlight so I'm fabbing up a bracket for it this weekend so that it'll mount to the lower fork bolts.


I've also gone back and forth about gas tanks. Do I like the K8 tank if I had another choice? Is there something better looking? I never gave it much thought before since the tank was clean and part of the bike. Since I now have the option and money to try something different, I decided to track down a 78 Supersport tank. I thought that the lines they have with my seat would make a really cool and unique combo.
I found a used, clean one after some extensive searching from the guys at Cycle X. I got it in and mounted it up. I ended up have to cut back my custom seat pan just a little bit so that it would lay under the rear of the tank and not wrinkle the seat covering.
These are the pictures before I did any cutting. I'll post some more once the tank gets back from the painter.



This past Tuesday I brought my wheels over to Working Class Cycles here in Philly to get my new Avon Road Riders mounted. While that was being done, I rigged up one of my cymbal stands to hold the front of the bike up so that I could change the fork seals. One of the seals I got from Cycle X were leaking so I decided to order some proper OEM ones. I made sure to smooth the seal surface and reinstalled the new seals with 15W fork oil. This should clear up that problem.


I also went back and forth with handlebars a little bit. I originally had some black superbike type bars on there, but once again, since I had the option to try something different, I tried Biltwell's tracker bars. I found them to be too low without enough pullback for my taste (Biltwell doesn't publish the rise or pullback specs) so I ended up selling those and picking up these Euro Style bars. They were really wide, so after cutting 3 3/8" off either side and getting my turn signal switch run though the bars, here they are mounted up.

