Just found this tread, so instead creating new one, I'll continue here
I just got new All Balls kit 22-1011.
Reading this tread and some others I understood following:
LOWER - I should place under lower bearing (order from bottom-up) : washer to compensate different height (based on measurement select 99-1011 or 99-1054), seal and then lower bearing
UPPER - for the upper part, I should assemble it as on attached leaflet : seal, washer 99-1101 and the original spanner nut. OR, alternatively, if there wil not be proper gap for ears, solution is to grind spanner nut.
Is that correct, please?
Additionally, I'm wondering why there are 2 kind of bearings - is there different dimension for upper and lower? The same for seals...
And lastly, something not discussed here (and did not find elsewhere) - what should be torque to tighten it?
Why I ask - I had quite some issues when I replaced stock bearings in my previous CBF1000F (SC64, 2010) by tappered one. Simply torque for tappered bearings had to be higher than required by shop manual for standard (25Nm)
Here is kit content I received and leaflet