Author Topic: 85 fz 750  (Read 13412 times)

0 Members and 1 Guest are viewing this topic.

Offline grcamna2

  • Not a
  • Really Old Timer ...
  • *******
  • Posts: 15,231
  • I love to restore & travel. Keep'em Going Strong !
Re: 85 fz 750
« Reply #175 on: December 24, 2024, 06:27:24 PM »
How did your replacement fuel tank look Mark;did the inside look better than the original ?
75' CB400F/'bunch o' parts' & 81' CB125S modded to a 'CB200S'
  I love the small ones too !
Do your BEST...nobody can take that away from you.

Offline Mark1976

  • Hot Shot
  • ***
  • Posts: 698
Re: 85 fz 750
« Reply #176 on: December 24, 2024, 07:11:22 PM »
How did your replacement fuel tank look Mark;did the inside look better than the original ?
The replacement tank was great inside, everything worked and aside from two small dings, it had the fuel gauge sending unit and a decent petcock, no gas tank cap, bought a new one (only cost $25). Repaired/repainted the lower half silver again and a couple of coates of clear later, and it was done. I spent $225 total on the tank, cap and paint. A steal in today's world. It still has the original graphics (which are checked) and the original red on top. Re-cleared the entire tank to preserve the upper half. Might, might..... Repaint the entire tank and apply new graphics in the spring, there just sitting on a shelf, but the red on the tank has a rainbow like flake in it (very fine) and I've not found a reproduction color of that yet. There's the solid red (Toyota color) available, just not with flake in it. So yeah we'll see...
Start with the end in mind...

Offline grcamna2

  • Not a
  • Really Old Timer ...
  • *******
  • Posts: 15,231
  • I love to restore & travel. Keep'em Going Strong !
Re: 85 fz 750
« Reply #177 on: December 24, 2024, 07:40:56 PM »
Mark,do you know if a person can install some type of risers that will accept regular handlebars ?
75' CB400F/'bunch o' parts' & 81' CB125S modded to a 'CB200S'
  I love the small ones too !
Do your BEST...nobody can take that away from you.

Offline Mark1976

  • Hot Shot
  • ***
  • Posts: 698
Re: 85 fz 750
« Reply #178 on: December 24, 2024, 07:54:31 PM »
Mark,do you know if a person can install some type of risers that will accept regular handlebars ?
   So, I've seen where there are adaptations for conventional bars, whether or not that means you could install a riser and then round stock conventional bars, I don't know. The bar setup as it is, really isn't that low. It may have been in 1985 but by today's standards, its standard.
Start with the end in mind...