Author Topic: T500 suckin oil  (Read 1315 times)

0 Members and 2 Guests are viewing this topic.

Offline johnyvilla

  • Hot Shot
  • ***
  • Posts: 516
T500 suckin oil
« on: August 14, 2007, 11:46:29 PM »
I rebuilt my 70' Suzuki T500s motor a few years ago without fitting new rubber seals within. She ran great for two years, but is now smoking entirely to much. Apparently, one can barely see the road riding behind me at WOT. Also, for the first time my crankcase oil level regularly drops after long rides. So I assume its not the 2stroke injection pump because I'm loosing crankcase oil. But can I also assume the rubber oil rings that seat on eather side of the crank are to blame? Like I said I haven't been in there for a few years and I cant remember what kind of internal seals exist. Is anyone familiar with these engines? thanks

Offline 333

  • Time for change
  • Really Old Timer ...
  • *******
  • Posts: 7,557
  • Mail List Member #162 - Call me Stan
Re: T500 suckin oil
« Reply #1 on: August 15, 2007, 05:39:56 PM »
I'm not that familiar with the T500, but if it's a 2-stroke, it doesn't have crankcase oil.  It has transmission oil.  And if it is losing oil when ridden, and it's not leaking on to the ground, I would have to guess a seal between the tranny and engine case has gone bad.  Are you sure those o-rings aren't true oil seals?  They do go bad sometimes.
Go metric, every inch of the way!

CB350F0  "Scrouching Tiger"
CT70K0    "Sneezing Poodle"

www.alexandriaseaport.org

Offline mark

  • finds nothing amusing about being an
  • Old Timer
  • ******
  • Posts: 2,939
  • we're out here and this is where we are.
Re: T500 suckin oil
« Reply #2 on: August 15, 2007, 10:50:21 PM »
Had to dig a bit but found the old Clymer book. The pix show an oil seal behind the main bearing on the clutch side. The other possibility would be the sealer on the case halves between the crankcase and transmission. Crankcase vacuum on the compression stroke could pull trans. oil through a leak at either place. I do not see a  fix for either without scattering it again. Sorry.

Hope that helps a bit.

Happy trails.
1976 CB550K, 1973 CB350G, 1964 C100

F you mark...... F you.

Offline johnyvilla

  • Hot Shot
  • ***
  • Posts: 516
Re: T500 suckin oil
« Reply #3 on: August 16, 2007, 04:53:54 AM »
Thanks guys that helps.

Offline bryanj

  • Really Old Timer ...
  • *******
  • Posts: 14,026
  • CB500 Number 1000036
Re: T500 suckin oil
« Reply #4 on: August 17, 2007, 04:20:14 AM »
Crank seals go with age, change bothe outers, if the centre is rubber as well thats a crank split (specialist) job
Semi Geriatric ex-Honda mechanic and MOT tester (UK version of annual inspection). Garage full of "projects" mostly 500/4 from pre 73 (no road tax in UK).

Remember "Its always in the last place you look" COURSE IT IS YOU STOP LOOKIN THEN!